0
Your Cart
0
Your Cart
Note:
  • Pressure: Determined by maximum working pressure for hose size.
  • CAUTION: Sealing integrity may be damaged by the use of clamps.
  • Label Set: FS-500
Material:
  • CA360 Brass
Compatible Hose:
  • H100, H101, H201, H332, 35FH
Assembly instructions:
  • To determine the correct length of hose, subtract the cut-off factor for each end Fitting from the overall length of assembly.
  • 1. Lubricate insert.
  • 2. Hold hose at angle as shown and push on and up over first barb.
  • 3. Continue to push straight on until hose is seated under protective plastic cap. (Keep hand back from hose end area so that hose can expand.)
  • Assembly Lubricant:
    • 1 Gallon: 222070-8
    • 1 Pint: 222070
Disassembly instructions:
  • 1. Split hose as shown. Do not cut completely through hose. Sealing edge of barb could be damaged.
  • 2. Bend hose and remove with quick pull.
Brass
Part Number
Hose
I.D.
A Hose Cut-off
Factor
Hole
Diameter
Hex
E
10004B-Y04 1/4″ 1.86″ 0.38″ 0.172″ 1/2″
10005B-Y05 5/16″ 2.04″ 0.44″ 0.234″ 9/16″
10006B-Y06 3/8″ 2.14″ 0.44″ 0.297″ 5/8″
10008B-Y08 1/2″ 2.46″ 0.50″ 0.391″ 3/4″

Note: Drawings may differ from actual parts.

Reviews

There are no reviews yet.

Be the first to review “10006B-Y06 Weatherhead by Danfoss | Hose Mender Field Attachable Push-On Fitting | 100 ‘B’ Series Barb-Tite | -06 Push-On Hose Barb x -06 Push-On Hose Barb | Brass”

Your email address will not be published. Required fields are marked *